Force10 Networks Force10 User Manual download pdf (Page 27)

Installing and Maintaining the E1200i System 27

This chapter provides instructions to rack mount your E1200i DC system into a standard 19-inch or

23-inch equipment rack. It contains the following sections:

• Unpacking the E1200i DC System

• Installing the Equipment Rack Shelf Bar

• Standard Front Chassis Mounting

• Installing the Chassis into an Equipment Cabinet

Unpacking the E1200i DC System

The E1200i DC system and components are shipped on a wooden pallet with Front Shipping cover.

Remove the chassis from the shipping packaging and move the chassis with a hand cart, pallet jack, or fork

lift to its rack. Do not unpack the power supplies, fan trays, air filter, or cards until the chassis is installed.

Chapter 5 Installing the DC Chassis

Warning: The E1200i DC shipping containers each weigh up to 400 pounds. The unpacked

chassis and pallet weigh approximately 200 pounds. Do not attempt to lift or move the chassis

without the use of a hand cart, pallet jack, or forklift.

Caution: Lift the E1200i DC chassis only with the handles provided or from the bottom. Lifting by

the chassis shelves will cause chassis damage. Do not remove the shipping cover during the

installation process. The cover prevents damage to the internal framework and EMI seals.

Warning: Electrostatic discharge (ESD) damage can occur when components are mishandled.

Always wear an ESD-preventative wrist or foot-heal ground strap when handling RPMs, SFMs, or

line cards. After you remove the original packaging, place RPMs, SFMs, and line cards directly

into the chassis or on an antistatic surface.

Warning: Complete the chassis installation into the rack before you install any other component

(fan trays, power supplies, line cards, RPMs, SFMs, cables).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 104 105

No comments

Force10 Networks Force10 User Manual Page 27